H2 V8-6.2L (2008)
Fuel Filler Hose: Service and Repair
Fuel Tank Filler Hose Replacement
Fuel Tank Filler Hose Replacement
Removal Procedure
1. Clean all the fuel pipe and hose connections and the surrounding areas before disconnecting in order to avoid possible contamination of the fuel
system.
2. Drain the fuel below the level of the filler tube and hose assembly. Refer to Fuel Tank Draining (See: Service and Repair/Procedures) .
3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
4. Loosen the fuel fill hose clamp at the fuel tank.
5. Loosen the fuel fill hose clamp at the fuel fill pipe.
6. Remove the fuel fill hose and the hose clamps.
7. Cap the fuel tank opening.
Installation Procedure
1. Uncap the fuel tank opening.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the fuel fill hose and the hose clamps to the fuel fill pipe.
Tighten the clamps to 2.5 N.m (22 lb in).
3. Lower the vehicle.
4. Refill the fuel system.
