H2 V8-6.2L (2008)
Fuel Filler Hose: Service and Repair
Fuel Tank Filler Pipe Replacement
Fuel Tank Filler Pipe Replacement
Removal Procedure
1. Clean all the fuel pipe and hose connections and the surrounding areas before disconnection in order to avoid possible contamination of the fuel
system.
2. Remove the fuel filler cap.
3. Drain the fuel below the level of the fuel filler hose. Refer to Fuel Tank Draining (See: Service and Repair/Procedures) .
4. Remove the fuel fill pipe housing/bezel to fuel fill pipe bolts.
5. Remove housing/bezel by rotating clockwise.
6. Remove the left rear wheelhouse panel. Refer to Wheelhouse Panel Replacement (See: Body and Frame/Fender/Front Fender/Front Fender
Liner/Service and Repair) .
7. Disconnect the rear axle vent and air spring compressor hoses from the retainer on the fuel fill pipe, if applicable.
8. Loosen the fuel vent hose to fuel tank clamp.
9. Loosen the fuel fill hose to fuel tank clamp.
10. Disconnect the fuel fill pipe bracket bolt.
11. Disconnect the fuel fill and vent hoses from the fuel tank.
12. Remove the fuel fill and vent pipe and hose assembly.
13. Cap the open end of the fuel tank.
Installation Procedure
1. Uncap the fuel tank.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the fuel fill and vent pipe hose assembly to the fuel tank.
Tighten the clamps to 2.5 N.m (22 lb in).
3. Install the fuel fill pipe bracket bolt.
