H2 V8-6.2L (2008)
6. Install the steering gear pitman shaft seal retaining ring (2) into the steering gearing housing (1) using pliers J 4245 .
7. Coat the dust seal (2) with grease and install it into the steering gear housing (1).
8. Install the pitman arm boot (3) onto the steering gear housing (1).
Important: Do not install the pitman arm until all components have been installed onto the steering gear housing.
9. Install the steering gear pitman shaft and housing cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle (See:
Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle) .
10. Install the pitman arm (4) to the steering gear (1). Refer to Pitman Arm Replacement (See: Pitman Arm/Service and Repair) .
11. Adjust the steering gear pitman arm shaft over center pre-load as needed. Refer to Steering Gear Pitman Shaft Over-Center Preload Adjustment -
Off Vehicle (See: Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle) .
12. Install the steering gear. Refer to Steering Gear Replacement (See: Steering Gear Replacement) .
