H2 V8-6.2L (2008)
Differential Output Shaft Bearing: Service and Repair
Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement
Tools Required
*
J 2619-01 Slide Hammer
*
J 29369-2 Bushing and Bearing Remover (2-3 inch)
*
J 36609 Axle Tube Bearing Installer
*
J 45225 Axle Seal Installer
*
J 8092 Universal Driver Handle - 3/4 in - 10
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Drain the differential carrier assembly. Refer to Front Axle Lubricant Replacement (See: Fluid - Differential/Service and Repair/Removal and
Replacement/Front Drive Axle) .
3. If replacing the right side seal, perform the following steps:
1. Remove the inner axle shaft and housing assembly from the differential carrier case assembly. Refer to Front Drive Axle Inner Shaft and Inner
Shaft Housing Replacement (See: Service and Repair/Removal and Replacement/Front Drive Axle/Front Drive Axle Inner Shaft and Inner
Shaft Housing Replacement) .
2. Install the inner axle shaft housing into a vise.
Clamp only on the mounting flange of the inner axle shaft housing.
3. Install the J 29369-2 behind the inner axle shaft seal.
4. Install the J 2619-01 (2) to the J 29369-2 (1).
5. Remove the inner axle shaft seal using the J 2619-01 .
