H2 V8-6.2L (2008)
4. If replacing the right side bearing, perform the following steps:
1. Remove the inner axle shaft and housing assembly from the differential carrier case assembly. Refer to Front Drive Axle Inner Shaft and Inner
Shaft Housing Replacement (See: Service and Repair/Removal and Replacement/Front Drive Axle/Front Drive Axle Inner Shaft and Inner
Shaft Housing Replacement) .
2. Install the inner axle shaft housing into a vise.
Clamp only on the mounting flange of the inner axle shaft housing.
3. Install the J 29369-2 behind the inner axle shaft seal.
4. Install the J 2619-01 (2) to the J 29369-2 (1).
5. Remove the inner axle shaft seal using the J 2619-01 .
6. Install the J 29369-2 behind the inner axle shaft bearing.
7. Install the J 2619-01 (2) to the J 29369-2 (1).
8. Remove the inner axle shaft bearing using the J 2619-01 .
5. If replacing the left side seal and/or bearing, perform the following steps:
1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (See: Differential Carrier/Service and Repair) .
2. Place the differential carrier assembly into a vise.
Clamp only on the mounting flange of the differential carrier assembly case.
3. Remove the inner axle shaft using a hammer and a brass drift.
4. Install the J 29369-2 (2) behind the inner axle shaft seal or the inner axle shaft bearing as necessary.
5. Install the J 2619-01 (1) to the J 29369-2 (2).
6. Remove the inner axle shaft seal and/or the inner axle shaft bearing using the J 2619-01 .
Installation Procedure