H2 V8-6.2L (2008)
Housing Replacement) .
5. If installing the left side bearing and/or seal, perform the following steps:
1. Install the bearing with the square shoulder in using the J 36609 (2) and the J 8092 (1).
2. Install the new axle shaft seal using the J 45225 and the J 8092 .
3. Install the inner axle shaft into the differential case side gear using a soft-faced mallet until the retaining ring on the inner axle shaft is fully
seated within the groove in the differential case side gear.
4. Pull back on the inner axle shaft to ensure that the inner axle shaft is properly retained in the differential case side gear.
5. Install the front differential carrier assembly. Refer to Differential Carrier Assembly Replacement (See: Differential Carrier/Service and
Repair) .
6. Fill the differential carrier assembly. Use the proper fluid. Refer to Front Axle Lubricant Replacement (See: Fluid - Differential/Service and
Repair/Removal and Replacement/Front Drive Axle) .
7. Lower the vehicle.