H2 V8-6.2L (2008)
Housing Replacement) .
5. If installing the left side bearing and/or seal, perform the following steps:
1. Install the bearing with the square shoulder in using the J 36609 (2) and the J 8092 (1).
2. Install the new axle shaft seal using the J 45225 and the J 8092 .
3. Install the inner axle shaft into the differential case side gear using a soft-faced mallet until the retaining ring on the inner axle shaft is fully
seated within the groove in the differential case side gear.
4. Pull back on the inner axle shaft to ensure that the inner axle shaft is properly retained in the differential case side gear.
5. Install the front differential carrier assembly. Refer to Differential Carrier Assembly Replacement (See: Differential Carrier/Service and
Repair) .
6. Fill the differential carrier assembly. Use the proper fluid. Refer to Front Axle Lubricant Replacement (See: Fluid - Differential/Service and
Repair/Removal and Replacement/Front Drive Axle) .
7. Lower the vehicle.
Front Differential Drive Pinion Flange/Yoke, Seal, and Dust Deflector Replacement
Front Differential Drive Pinion Flange/Yoke, Seal, and Dust Deflector Replacement
Tools Required
*
J 8614-01 Flange and Pulley Holding Tool
*
J 36366 Pinion Oil Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Drain the drive axle. Refer to Front Axle Lubricant Replacement (See: Fluid - Differential/Service and Repair/Removal and Replacement/Front
Drive Axle) .
3. Remove the tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and
Repair) .
4. Remove the brake calipers. Refer to Front Brake Caliper Replacement (See: Brakes and Traction Control/Disc Brake System/Brake
Caliper/Service and Repair/Removal and Replacement/Front Brake Caliper Replacement) .
5. Remove the engine protection shield. Refer to Engine Protection Shield Replacement (See: Body and Frame/Frame/Skid Plate/Service and Repair
) .
6. Reference mark the relationship of the propeller shaft to the front axle pinon yoke.
7. Remove the yoke retainer bolts (6) and the yoke retainers (7) from the front axle pinion yoke (1).