H2 V8-6.2L (2008)
Seals and Gaskets: Service and Repair
Rear Output Shaft Seal Replacement
Rear Output Shaft Seal Replacement
Tools Required
J 45756 Rear Output Shaft Seal Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance) .
2. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Rear Propeller Shaft Replacement) .
3. Remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.
Installation Procedure
1. Using J 45756 , install a NEW front output shaft seal.
2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Rear Propeller Shaft Replacement) .
3. Check the fluid level. Add fluid, if necessary.
4. Lower the vehicle.
