Santa Fe GLS V6-2.7L (2002)
NOTE: Do not mix R.H. and L.H. parts.
INSPECTION
1. Check the side gears, pinions, pinion thrust washers, and cross shaft for wear or damage. If there is excessive wear, cracks, nicks, grooves or
galling, replace the parts.
2. Inspect the carbon surfaces. After cleaning with a solvent, the carbon surface should appear a course weave fabric with flat spots on the peaks of
the weave. If the surface is smooth, either from wear or from the weave filled with debris, replace the entire disc pack.
3. Measure the thickness of the carbon friction discs. If the measurements is below the limit value, replace the disc.
4. Inspect the splined friction discs. If they have grooves or are polished, replace the entire disc pack. Small scratches on them are O.K.
SHIM SELECTION FOR CLUTCH DISC
1. Measurement for R.H. pocket
Measure the R.H. pocket with the pinion shaft installed as shown in illustration.
2. Measurement for L.H. pocket
Measure the L.H. pocket with the pinion shaft installed according to the following formula as shown in illustration.
L.H. POCKET = A + B - C
3. Measurement for the side gear sub height.