Amigo 4WD L4-2.3L (4ZD1) (1989)
Brake Caliper: Service and Repair
Rear Caliper
Removal and Installation
1.
Raise and support vehicle and remove rear wheels.
2.
Disconnect flexible brake hose.
3.
Remove caliper lockpin.
4.
Remove caliper assembly from disc.
5.
Reverse procedure to install, tighten caliper lockpin and brake hose retaining bolt to specification.
Disassembly and Reassembly
Fig. 4 Rear Caliper, Exploded View
Fig. 5 Rear Caliper, Exploded View
1.
Remove caliper.
2.
Remove guide pin boot, then the sleeve and sleeve boot.
3.
Remove piston boot ring using small screwdriver.
4.
Remove piston dust boot.
5.
Insert a piece of wood into caliper and force piston out by applying compressed air through brake hose opening in caliper.
6.
Remove caliper to piston seal.
7.
Remove breather with cap.
8.
Reverse procedure to assemble, installing new guide pin boot, sleeve boot, piston boot ring, piston boot, and caliper piston seal supplied with