Hombre S Regular Cab 4WD V6-4.3L (1999)
Parking Brake Shoe: Service and Repair
Park Brake Shoe Replacement
Removal Procedure
1. Raise the suitably support the vehicle.
2. Remove the wheel and the tire.
3. Remove the caliper.
4. Remove the rotor.
5. Remove the park brake cable from the park brake lever.
6. Remove the park brake shoe assembly by sliding the shoe towards the hold down spring until the shoe is disengaged from the spring.
7. Remove the shoe from the actuation mechanism.
8. Clean the debris and the dust from the park brake components using a clean towel.
9. Turn the adjustment screw to the fully home position in the notched adjustment nut, then back off the nut 1/4 turn.
10. Align the slots in both the adjusting screw and tappet to be parallel with the backing plate face.
Installation Procedure
1. Install a new park brake shoe.
2. Position the shoe on the inboard side of the actuation mechanism.
3. Clip the shoe on the hold down spring.
4. Inspect the shoe assembly position. The shoe must be central on the backing plate and with both tips located in the slots.
5. Manually check the park brake for proper operation.
6. Install the park brake cable to the park brake lever.
7. Adjust the park brake shoe.
8. Install the caliper.
9. Install the rotor.
10. Install the tire and wheel.
11. Lower the vehicle.
