Hombre S Regular Cab 4WD V6-4.3L (1999)
Engine Accessory Bracket: Service and Repair
Generator Bracket
Accessory Mounting Brackets Replacement (Generator Bracket)
Removal Procedure
1. Disconnect the battery negative cable.
2. Remove the engine cooling fan.
3. Remove the drive belt.
4. Remove the generator.
5. Remove the engine wiring harness bracket from the generator mounting bracket.
6. Remove the drive belt tensioner.
7. Remove the drive belt idler pulley.
8. Remove the three bolts and nut holding the generator mounting bracket to the engine.
9. Slide the generator mounting bracket off of the stud.
Installation Procedure
1. Slide the generator mounting bracket onto the stud.
2. Install the two generator mounting bracket bolts and the nut.
Tighten the generator mounting bracket bolts and nut to 41 N.m (30 lb ft).
3. Install the drive belt idler pulley.
4. Install the drive belt tensioner.
