Hombre S Regular Cab 4WD V6-4.3L (1999)
-
J 6083 Snap Ring Pliers
-
J 9398-A Bearing Remover
-
J 34992 Holding Fixture
NOTE: Do not support the rotor by resting the pulley rim on a flat surface during the bearing installation or the rotor face will be bent.
1. Place the pulley rotor on the J 21352-A in order to fully support the rotor hub during bearing installation.
2. Use the following tools in order to align the new bearing squarely with the hub bore.
-
The J41552
-
The J9481-A
-
J 29886
3. Drive the bearing fully into the hub.
The installer will apply force to the outer race of the bearing, if used as shown.
4. Place the J 33019 in the hub bore.
5. Shift the rotor and bearing assembly on the J 21352-A in order to fully support the hub under the staking pin location.
Use a heavy-duty rubber band (1) in order to hold the stake pin in the guide. Properly position the stake pin in the guide after each impact on the
pin.
IMPORTANT: Use care in order to prevent personal injury when striking the staking pin with a hammer.
6. Strike the staking pin with a hammer until a metal stake, similar to the original, forms down to but not touching the bearing.