Hombre S Regular Cab 4WD V6-4.3L (1999)
IMPORTANT: Noisy bearing operation and reduced bearing life may result if the outer bearing race is deformed while staking. Ensure that the
stake metal does not contact the outer race of the bearing.
7. Stake 3 locations on the bearing race 120 degrees apart as shown.
8. With the compressor mounted on the J 34992, position the pulley rotor (1) and the bearing assembly on the front head.
9. Position the J 33017 and the J 33023-A directly over the inner race of the bearing.
10. Position the J 8433-1 on the J 33023-A.
11. Assemble the 2 through bolts and the washers through the puller bar slots.
12. Thread the through bolts into the J 34992.
Ensure that the thread of the through bolts engage the full thickness of the J 34992.
13. Tighten the center screw in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the compressor front head
If the J 33017 slips off direct in-line contact with the inner race of the bearing, perform the following steps:
1. Loosen the J 8433-3.
