Hombre S Regular Cab 4WD V6-4.3L (1999)
7. Remove the seal (1)from the compressor using a rotary-pulling motion. Discard the seal.
8. Securely hand-tighten the handle. Do not use a wrench or pliers.
9. Remove and discard the seal seat O-ring (1) from the compressor neck using the J 9553-01.
10. Inspect the shaft and the inside of the compressor neck for dirt or foreign material. Ensure that the shaft and the inside of the compressor neck are
perfectly clean before installing the new parts.
11. Thoroughly clean the O-ring seal groove in the front head.
Installation Procedure
Tools Required
-
J 39500 R-134a A/C Refrigerant Recovery, Recycling and Recharging System (ACR4)
-
J 5403 Snap Ring Pliers
-
J 23128-A Seal Seat Remover and Installer
-
J 33011 O-Ring Installer
-
J 34614 Shaft Seal Protector
-
J 39893 Pressure Testing Connector
NOTE: Seals should not be re-used. Always use a new specification service seal kit. Be sure that the seal to be installed is not scratched or damaged in
any way. Make sure that the seal is free of lint and dirt that could damage the seal surface or prevent sealing.
