Hombre S Regular Cab 4WD V6-4.3L (1999)
1. Dip the new seal seat O-ring in clean 525 viscosity refrigerant oil. Assemble the new seal seat O-ring onto the J 33011.
2. Insert the J 33011 into the compressor neck until the installer bottoms.
3. Lower the moveable slide of the J 33011 in order to release the O-ring into the seal O-ring lower groove.Do not release the O-ring into the
compressor neck top groove.
4. Rotate the J 33011 in order to seat the O-ring.
5. Remove the J 33011.
6. Dip the new seal in clean 525 viscosity refrigerant oil. Assemble the seal to the J 23128-A by turning the handle clockwise.
7. Engage the knurled tangs of the J 23128-A with the stamped steel case side of the lip seal (1) in order to ensure that the flared-out side of the lip
seal (1) faces toward the compressor.
NOTE: Handling and care of the seal protector is important. If the seal protector is nicked or the bottom flared, the new seal may be damaged
during installation.
8. Install the seal using I of the 2 following methods: