Hombre S Regular Cab 4WD V6-4.3L (1999)
5. Install the connector and the connector position assurance (CPA) retainer to the BTSI.
6. Install the 2 wire straps on the steering column wire harness.
7. Install the steering column upper and lower shrouds.
8. Install the steering column bracket nuts.
Tighten
Tighten the steering column bracket nuts to 30 N.m (22 lb ft).
9. Install the knee bolster.
10. Ensure the lever is in the center or the OFF position.
Turn Signal and Multifcn SW Assembly
Turn Signal and Multifcn Sw Assembly - Disassemble (Column Shift)
Disassembly Procedure
1. Remove the upper and lower shrouds. Refer to Shrouds, Shift Lever Seal - Disassemble (Column Shift).
2. Remove the wire harness straps (2) from the wire harness assembly (1) and the steering column.
3. Disconnect the turn signal and multifunction switch assembly connector from the SRS coil assembly connector.
4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
