Hombre S Regular Cab 4WD V6-4.3L (1999)
Distributor: Service and Repair
Overhaul
Disassembly Procedure
NOTE: Refer to Distributor Driven Gear Can Be Installed in Multiple Positions in Service Precautions.
Installing the driven gear 180 degrees out of alignment, or locating the rotor in the wrong holes, will cause a no-start condition. Premature engine wear
or damage may result.
1. Remove the two screws that hold the distributor cap to the housing.
2. Discard the screws.
3. Remove the distributor cap from the housing.
4. Align white paint mark on the bottom stem of the distributor, and the pre-drilled indent hole in the bottom of the gear (3).
5. With the gear in this position, the rotor segment should be positioned as shown for a V6 engine (1) or V8 engine (2) If not, replace the distributor.
