Hombre S Regular Cab 4WD V6-4.3L (1999)
52.
Install the clamp (2) and nuts (1), and torque nuts to 3 N.m (27 lb in). (Figure 11)
53.
Apply threadlock or equivalent to the threads of the fuel pipe bolt (4). Install the fuel pipe bolt and torque fuel pipe bolt to 6 N.m (53 lb in).
(Figure 11)
54.
Install the brake booster vacuum hose and connector to the intake manifold.
55.
Install the bonnet and air inlet tube to the throttle body.
56.
Install the PCV fresh air tube to the inlet duct.
57.
Install ignition wires 1, 3, and 5 to the distributor cap.
58.
Add one (1) ounce of Fuel System Treatment, to the vehicle fuel tank for each gallon of gasoline estimated to be in the tank. Instruct the customer
to add the remainder of the bottle of Fuel System Treatment to the vehicle fuel tank at the next fill-up.
59.
Tighten the fuel tank filler cap.
60.
Start the vehicle and check for fuel leaks.
61.
Using the Tech 2 scan tool, check for any stored Powertrain DTC codes. Clear codes as required.
62.
Disconnect the Tech 2 scan tool.
63.
Advise the customer to change brands of fuel.
Step 3: Replacement of SCPI fuel assembly
If after cleaning the SCPI poppet nozzles, the normal service manual diagnosis still indicated that the SCPI is the cause of the customer complaint,
refer to the appropriate Workshop Manual to replace the SCPI fuel assembly.
