Hombre S Regular Cab 4WD V6-4.3L (1999)
5. Pull the connection apart.
NOTE: If it is necessary to remove rust or burrs from a fuel pipe, use emery cloth in a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface.
6. Using a clean shop towel, wipe OFF the male pipe end.
7. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.
INSTALLATION
1. CAUTION: In order to reduce the risk Of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine
oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
2. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
3. Apply a few drops of clean engine oil to the male pipe end.
4. Push both sides of the fitting together to cause the retaining tabs to snap into place.
5. Once installed, pull on both sides of the fitting to make sure the connection is secure.
