Hombre S Regular Cab 4WD V6-4.3L (1999)
4. Insert a screwdriver into each access hole and push the leaf spring to release the pin that retains the inflator module.
5. Turn the steering wheel 180 degrees to gain access to the remaining access holes.
6. Insert a screwdriver into each access hole and push the leaf spring to release the pin that retains the inflator module.
7. Tilt the top of the inflator module rearward to gain access to the SRS wiring.
8. Disconnect the SRS lead wire from the clip on the inflator module.
9. Disconnect the SRS lead wire from the clip on the steering wheel.
10. Disconnect the connector position assurance (CPA) retainer.
11. Disconnect the electrical connector.
12. Remove the inflator module from the vehicle.
