Hombre S Regular Cab 4WD V6-4.3L (1999)
12. Disconnect the idler arm ball stud from the relay rod using J 24319-B.
13. Remove the relay rod.
14. Inspect the following components:
-
The threads on the tie rod for damage
-
The threads on the tie rod end for damage
-
The ball stud threads for damage
-
The ball stud seals for excessive wear
15. Clean the threads on the ball stud.
16. Clean the threads on the ball stud nut.
Installation Procedure
Tools Required
-
J 29193 Steering Linkage Installer (12mm)
-
J 29194 Steering Linkage Installer (14mm)
1. Install the idler arm ball stud to the relay rod.
Ensure that the seal is on the rod.
2. Seat the taper using J 29193 or J 29194.
Tighten
Tighten J 29193 or 29194 to 54 N.m (40 lb ft).
3. Remove J 29193 or J 29194 from the idler arm ball stud.
4. Install the new nut to the idler arm ball stud at the relay rod.
Tighten
Tighten the idler arm ball stud nut to 82 N.m (60 lb ft).
