Hombre XS Space Cab L4-2.2L CPC (1997)
Push Rod: Service and Repair
REMOVAL
1. Remove the valve rocker arm cover.
2. Remove the valve rocker arms.
NOTE:
^
Inspect the valve rocker arm and ball surfaces for excessive wear and burrs. Replace if needed.
^
Make sure to keep parts in order. Parts must be put back from where they were removed.
3. Remove the pushrods.
NOTES:
^
Check the pushrod for straightness. Roll the pushrod on a flat surface to determine if the pushrod is bent. Replace if necessary.
^
Inspect the pushrods for excessive wear. Replace if necessary.
^
When you install new rocker arms and new rocker arm balls, coat the mating surface with camshaft assembly lubricant or equivalent.
^
Make sure that the pushrod is seated properly in the valve lifter and the rocker arm to avoid possible engine damage.
INSTALLATION
1. Install the pushrods.
2. Install the valve rocker arms.
3. Install the valve rocker arm balls.
NOTE: Do not over tighten the rocker arm nuts
4. Install the rocker arm nuts.
^
Tighten the rocker arm nuts to 30 Nm (22 ft. lbs.).
5. Install the valve rocker arm cover.
