Hombre XS Space Cab L4-2.2L CPC (1997)
Wheel Bearing: Service and Repair
Front
REMOVAL
NOTE: The Special Service Tool (SST) required
to complete this replacement is a J 29117-A wheel bearing cup remover.
1. Raise the vehicle and support it with safety stands,then remove the brake caliper.
NOTE: Suitably support the caliper to prevent damage to the brake hose.
2. Remove the bearing cap from the rotor.
3. Remove the cotter pin, nut, and washer, then remove the rotor from the spindle being careful not to damage the outer bearing and spindle threads.
4. Remove the outer bearing and pry the seal out and discard it.
5. Remove the inner bearing using the J 29117-A tool to remove the inner race.
6. Clean all the parts in a solvent and air dry. Do not spin the bearings with compressed air. Make sure all parts are clean and free of grease.
7. Inspect the rotor, bearings and races for a cracked cage, worn or pitted rollers, cracks, scores, or a brinelled condition.
INSTALLATION
NOTE: Apply an approved high-temperature front wheel bearing grease to the spindle at the inner and outer bearing seat, shoulder, and seal seat. Also
use a finger to apply a small amount of grease inboard of each bearing cup in the rotor. Pressure pack the bearings with a greasing machine or hand pack
them, making sure the grease is worked thoroughly into the rollers, cone, and cage.
1. Insert the inner bearing into the rotor, applying an additional quantity of grease outboard of the inner bearing.
2. Install the seal and do the following.
a. Lubricate the seal lip.
b. Use a flat plate to press the seal down flush with the hub.
c. Seat the outer bearing and cup.
3. Place the rotor onto the spindle, being careful not to scuff the spindle threads.
