Hombre XS Space Cab L4-2.2L CPC (1997)
8. Cut two 4.6 m (15 ft) deployment wires from 0.8 mm (18 gauge) or thicker multistrand wire. Use these wires to fabricate the deployment harness.
9. Strip 13 mm (0.5 inch) of insulation from both ends of the wires cut in the previous step.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed:
^
Wear safety glasses throughout the procedures.
^
Make sure the area around the inflator module is clear of all people and loose or flammable objects.
^
Short the deployment harness wires as instructed.
^
Connect the deployment harness to the inflator module before you connect it to the power source.
^
Connect the deployment harness to the power source to immediately deploy the air bag.
Failure to follow the procedures in the order listed may result in personal injury.
10. Short the wires by twisting together one end from each. Deployment wires shall remain shorted, and not connected to a power source until you are
ready to deploy the air bag.
