Hombre XS Space Cab L4-2.2L CPC (1997)
18. Completely cover the windshield area and the front door window openings with a drop cloth, blanket or similar item. This reduces the possibility
of injury due to possible fragmentation of the vehicle's glass or interior.
19. Notify everyone in the immediate area that you intend to deploy the air bag. The deployment will be very load. This may startle any uninformed
people in the area.
20. Place a power source near the shorted end of the SRS deployment harness. Use a vehicle battery when available, but always use a power source
that complies to the following:
^
12 volts minimum
^
2 amps minimum
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed:
^
Wear safety glasses throughout the procedures.
^
Make sure the area around the Inflator module is clear of all people and loose or flammable objects.
^
Short the deployment harness wires as instructed.
^
Connect the deployment harness to the inflator module before you connect It to the power source.
^
Connect the deployment harness to the power source to immediately deploy the air bag.
Failure to follow the procedures in the order listed may result in personal injury
Important: The rapid gas expansion involved with deploying an air bag will be very load. Notify all the people in the immediate area that you
intend to deploy the inflator module.
21. Separate the two ends of the of the deployment harness wires.
22. Connect the deployment harness wires to a power source. This will immediately deploy the inflator module.
After the inflator module has deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily of cornstarch
(used to lubricate the bag as it inflates), and by-products of the chemical reaction. The deployment reaction produces sodium hydroxide dust
(similar to lye soap). The sodium hydroxide quickly reacts with the atmospheric moisture. This atmospheric moisture converts the sodium
