isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Warning Lamp Comes "ON" Steady|Page 4836 > < Warning Lamp Comes "ON" Steady|Page 4834
Page 4
background image

Air Bag Warning Lamp Comes On Steady (Part 3 Of 3)

TEST DESCRIPTION

Refer to step numbers on the diagnostic table.
1. Start at the SRS Diagnostic System Check for all diagnosis.
2. An open AIR BAG fuse would cause the AIR BAG warning lamp to come on steady.
3. A disconnected DERM harness connector will cause the warning lamp to come on steady via the shorting bar from terminal A1 to terminal B1.
9. This test checks for a open in the ground circuitry to the DERM.

11. This test checks for an open in the Ignition 1 circuitry to the DERM.
16. This test checks for a short from the Crank input to circuit to B+.
17. This test determines where the short-to-voltage is located in circuit 1035.

When measurements are requested in this table use J 39200 Digital Multimeter with correct terminal adapter from J 35616-A Connector Test
Adapter Kit. When a check for proper connection is requested, refer to Intermittents and Poor Connections. When a wire, connector or terminal

Warning Lamp Comes "ON" Steady|Page 4836 > < Warning Lamp Comes "ON" Steady|Page 4834