Hombre XS Space Cab L4-2.2L CPC (1997)
6.
From the Cushion Pad Protector Kit (Part No. 8-88880-006-0) mount the plastic protector cover onto the seatback recliner assembly so that both
the top and rear portion of the seatback recliner assembly are covered by the plastic protector cover and the mounting screw hole in the plastic
protector cover is aligned with the pre-drilled hole in the seatback recliner assembly (Figure 2). Insert the mounting screw, supplied from the kit,
into the mounting hole in the plastic protector cover and tighten the mounting screw until the plastic protector cover is securely attached to the
seatback recliner assembly (Figure 3).
IMPORTANT!
The edge of the plastic protector cover must be seated on both the upper and rear surface of the seat back recliner assembly.
7.
Install the side skirt seat trim with the new plastic fastener, supplied from the kit, and fasten the 4-strip onto the seat bottom seat trim.
8.
Repeat the above steps for the remaining seat portion.
APPLYING THE CAMPAIGN LABEL
