Hombre XS Space Cab L4-2.2L CPC (1997)
7. Take off the rear brace.
8. Remove the front mounting bolts.
9. After completing the procedures, remove the power steering pump.
NOTE:The Special Service Tool (SST) required to install the pump is a J 25033-B pulley installer.
INSTALLATION
1. Install the power steering pump and and tighten the front mounting bolts to 30 Nm (22 ft lbs).
2
.Attach the rear brace and tighten the nut and bolt to 30 Nm (22 ft. lbs.).
3. Install the filler neck tube.
4. Install the pulley following the procedures listed below.
a. Place pulley on the end of the pump shaft.
b. Install the Special Service Tool (SST) J 25033-B. Make sure the pilot bolt bottoms in the shaft by turning the nut to the top of the pilot bolt
by holding the pilot bolt and turn the nut clockwise.
c. Install pulley flush +/- 0.25 mm (0.010 inch) with the end of the power steering pump shaft.
5. Install the belt.
6. Load the tensioner assembly.
7. Attach the hoses.
8. Fill and bleed the system.
9. Inspect the hoses for clearance.