Hombre XS Space Cab 2WD V6-4.3L (1998)
22. Disconnect the SRS deployment harness from the power source after the air bag deploys.
23. Seat one banana plug into the other in order to short the deployment harness leads.
24. If the air bag did not deploy, disconnect the adapter and discontinue the procedure. Contact the Technical Assistance Group. Otherwise, proceed to
the following steps.
Warning: Immediately following the deployment of an air bag, the metal surfaces of the inflator module are very hot. Do not place the
deployed inflator module near any flammable objects. Wait for about ten minutes before touching any metal surface of the inflator module.
Disregarding these precautions may cause fire or personal injury.
25. Put on a pair of shop gloves.
26. Disconnect the pigtail adapter from the inflator module as soon as possible.
27. Inspect the pigtail adapter and the SRS deployment harness. Replace as needed.
28. Dispose of the deployed module through normal refuse channels.
29. Wash hands with a mild soap.
Deployed Air Bag Handling
When handling a deployed air bag assembly, a face shield and rubber gloves should be worn. Vehicle interior and A/C, vent, defroster and heater ducts
should be vacuumed. If sinus or throat irritation is encountered during air bag removal, exit vehicle and breathe fresh air. If skin irritation is encountered,
flush effected area with cool water. If sinus, throat, skin or any other type of irritation continues, consult a physician. After handling a deployed air bag
assembly, wash hands and rinse thoroughly with water.
An air bag that has been deployed should be removed from the vehicle. Prior to removing a deployed air bag assembly, place tape over air bag exhaust
vents. After unit has been removed, it should be placed in a heavy duty plastic bag and sealed securely. The sealed plastic bag should then be placed with
automotive scrap. An air bag assembly that has not been deployed, must be deployed prior to disposal.