Pickup 4WD L4-2559cc 2.6L SOHC (4ZE1) (1988)
/Page-456001.png)
Clutch Pedal Assembly: Adjustments
1.
On models equipped with cruise control, remove clutch switch connector then loosen locknut and turn switch out until there is a gap between
the switch plunger and clutch pedal.
2.
On models not equipped with cruise control, loosen clutch pedal adjusting bolt.
3.
On all models, loosen clutch master cylinder pushrod locknut then turn pushrod by hand to set clutch pedal height to 9.55 inches from firewall. On
Rodeo models w/4 cylinder engine set height to 6.7-7.1 inches. On Rodeo models w/V6 engine set height to 7.6-8.0 inches.
4.
Tighten pushrod locknut.
5.
On models equipped with cruise control, proceed as follows:
a. Turn clutch switch until switch plunger is fully retracted against clutch pedal arm.
b. Turn out switch one-half turn, then lock clutch switch locknut.
c. Connect clutch switch connector.
6.
On models not equipped with cruise control, tighten clutch pedal adjusting bolt until bolt contacts clutch pedal arm.
7.
On all models, ensure clutch pedal freeplay is 0.2-0.6 inch, if freeplay is not within specifications, repeat steps three through eight.
