Rodeo LS 4WD V6-3.2L (1998)
Drink Holders: All Technical Service Bulletins
Rear Cup Holder - Revised Strike Plate Latches
BULLETIN NUMBER:
SB98-13-L005
ISSUE DATE:
SEPTEMBER 1998
GROUP:
ACCESSORIES
1998 RODEO (UE) REAR CUP HOLDER LATCH REPLACEMENT
AFFECTED VEHICLES
1998 Rodeo (UE) models.
SERVICE INFORMATION
Early production 1998 Rodeo (UE) models were equipped with rear cup holders with bonded strike plate latches. These cup holders were later
redesigned with improved strike plate latches that are fastened with screws.
Condition:
The magnetic latches do not hold the rear cup holder lid closed.
Possible Cause:
The metal strike plate for the magnetic latches does not stay bonded to the plastic.
Correction:
Use the parts included in the rear cup holder repair kit (Part Number 2-90002-805-0) to:
- Install an improved strike plate onto the base.
- Replace the rear cup holder lid.
PARTS INFORMATION
WARRANTY CLAIM INFORMATION
Use the new labor operation.
Labor Time includes administrative time allowance.
SERVICE PROCEDURE
1.
Remove the entire cup holder assembly from the rear console by removing the two attachment screws.
2.
If the strike plate is still attached, pry loose the existing strike plate from cup holder base and discard.