Rodeo LS 4WD V6-3.2L (1998)
IMPORTANT!
The new door mirror sealing patches used for this repair have a "crack and peel" paper backing. This paper backing helps keep the adhesive surface
of the sealing patch free of fingerprints during installation to ensure optimum bonding of the sealing patch to its door mirror mounting hole surface.
For best results, carefully follow the instructions below.
Door Mirror Sealing Patch
(Driver-Side/Passenger-Side)
^
Place a new door mirror sealing patch (Part No. 8-97808-119-1) between thumb and index finger, with paper backing side facing upward and paper
backing seam running from left to right. Gently squeeze sealing patch edges to release paper backing halves from sealing patch.
^
Remove one half of paper backing from sealing patch and carefully position sealing patch, adhesive side up, onto door mirror mounting hole surface
(Figure 2).
IMPORTANT!
Be careful not to touch any of the exposed adhesive surface with your fingers. Dirt or oil from your fingers could affect adhesive bonding
effectiveness.
^
Carefully remove remaining paper backing from sealing patch; then, press sealing patch firmly into place, using a circular motion around outside
edges of sealing patch.
IMPORTANT!
Do not press down in the center portion of the sealing patch; there is no support in this area.
^
Repeat above steps for remaining door mirror sealing patches.
PARTS INFORMATION
Part No.
Description
Quantity Required
8-97808-119-1
Tape/Patch; Platform-Mirror
6
(door mirror sealing patch)
WARRANTY CLAIM INFORMATION
