Rodeo LS 4WD V6-3.2L (1998)
7. Remove bracket (5).
8. Lift up and remove the radiator assembly with hose, taking care not to damage the radiator core with a fan blade.
9. Remove rubber cushions on both sides at the bottom.
INSPECTION
Radiator Cap
Measure the valve opening pressure of the pressurizing valve with a radiator filler cap tester. Replace the cap if the valve opening pressure is outside
the standard range.
Valve opening pressure 88.3 - 117.7 kPa (12.8 - 17.1 psi)
Cap tester: J-24460-01
Adapter: J-33984-A
Check the condition of the vacuum valve in the center of the valve seat side of the cap. If considerable rust or dirt is found, or if the valve seat cannot
be moved by hand, clean or replace the cap.
Valve opening vacuum 1.96 - 4.91 kPa (0.28 - 0.71 psi)
Radiator Core
1. A bent fin may result in reduced ventilation and overheating may occur. All bent fins must be straightened. Pay close attention to the base of the
fin when it is being straightened.
2. Remove all dust, bugs and other foreign material.
Flushing The Radiator
Thoroughly wash the inside of the radiator and the engine coolant passages with cold water and mild detergent. Remove all signs of scale and rust.
Cooling System Leakage Check
