Rodeo LS 4WD V6-3.2L (1998)
2. On the right cylinder bank, turn the camshaft pulley until its green mark is at 12 o'clock in relation to the head surface, at the center of the head.
Turning the pulley brings the timing dots on the camshaft drive gear into their correct position: to the left and right of the gear's centerline.
3. On the left cylinder bank, turn the camshaft pulley until its green mark is at 12 o'clock in relation to the head surface, at the center of the head.
Then turn the pulley counterclockwise until its green mark points close to the timing belt cover bolt hole. Turning the pulley brings the timing dots
on the camshaft drive gear into their correct position: to the left and right of the gear's centerline.
4. Install the intake and exhaust camshafts in the right cylinder bank:
-
Set the camshaft marked "RI" into the intake side of the head. Make sure the single timing dot on the camshaft gear aligns with the timing dot
on the camshaft drive gear.
