Rodeo LS 4WD V6-3.2L (1998)
6. Install the drive plate to the compressor drive shaft together with the original shim(s)(1). Press the drive plate by hand.
7. Install drive plate bolt by using drive plate holder J-33939 (1) to prevent the drive plate from rotating.
- Tighten the drive plate bolt to the specified torque.
Torque: 13 N.m (113 lb.in)
- After tightening the drive plate bolt, check to be sure the pulley rotates smoothly.
- Check to be sure that the clutch clearance is between 0.3 - 0.6 mm (0.01 - 0.02 in.)
- If necessary, install adjusting shim(s).
- Adjusting shims are available in the following thickness.
Thickness
- 0.1 mm (0.0039 in.)
- 0.3 mm (0.0118 in.)
- 0.5 mm (0.0197 in.)