Rodeo LS 4WD V6-3.2L (1998)
^
Using a small screwdriver, carefully pry the float arm pivot (near the brass bushing) from the sending unit. (Figure 1)
IMPORTANTDO not allow any portion of the float arm to bend. Be sure the 90° bend near the pivot of the float arm is intact. A deformed float arm
will result in inoperative sending unit.
5.
Disconnect the (Blue/Black) harness connection from the fuel pump assembly. (Figure 2).
6.
Remove the (Red) locking clip and disconnect the harness connection from the top of the FPAS housing. (Figure 3)