Rodeo LS 4WD V6-3.2L (1998)
7.
Remove the (Black) locking clip and remove the sending unit from the FPAS
housing. (Figure 4)
8.
Replace the 0-ring at the top of the FPAS housing. (Figure 5)
9.
Before installing new sending unit, locate the electrical connector at the top of the fuel pump (near the center of the FPAS housing). This
connector is either a small or large type.
The service kit includes two sending units, each with the proper termination necessary for the two types of fuel pump connectors currently in existence.
Use only one sending unit with harness, which will properly connect to the fuel pump. Discard the other sending unit. (Figure 6)