Rodeo LS 4WD V6-3.2L (1998)
NOTE
The harness must be secured from surrounding components with the band clip to prevent possible damage to harness due to chafing.
5.
From under the hood, connect the new wire harness at the following locations:
^
Attach the harness clip behind the battery tray.
^
Loosely attach (P-6) ground terminal, near the fuse box
NOTE
Clean the ground area and fastening bolt with a wire brush. Replace the bolt if heavily corroded.
^
(H-3) Harness connector near the fuse box
^
(H-2) Harness connector near the fuse box
* NOTE
If previously equipped, inspect the proper connection of the Rear Defogger ACG (pigtail harness) into the (H-2) socket. (Refer to Step 5 Removal)
^
Torque the (P-6) ground terminal to (14 N.m) 10 lb.ft.
6.
Install the (P-6) ground terminal on the alternator support bracket, with 90° bend at top. (Figure 11)
NOTE
Clean the ground area and fastening bolt with a wire brush. Replace the bolt if heavily corroded.
7.
Install the new band clip to the harness under the battery tray. (Figure 12)
NOTE