Rodeo S 2WD L4-2.2L (1999)
4. Remove dust boot ring, using a small screwdriver.
5. Insert a block of wood into the caliper and force out the piston by blowing compressed air into the caliper at the flexible hose attachment. This
procedure must be done prior to removal of the dust boot.
Remove piston.
WARNING: DO NOT PLACE YOUR FINGERS IN FRONT OF THE PISTON IN AN ATTEMPT TO CATCH OR PROTECT IT
WHEN APPLYING COMPRESSED AIR. THIS COULD RESULT IN PERSONAL INJURY.
CAUTION: Use just enough air to ease the piston out of the bore. If the piston is blown out, it may be damaged.
6. Remove dust boot: piston.
7. Remove piston seal.
8. Remove bleeder with cap.
9. Remove caliper body.
REASSEMBLY
1. Install caliper body.
2. Install bleeder with cap and tighten the cap to the specified torque.
Torque: 8 Nm (69 inch lbs.)
