Rodeo S 2WD L4-2.2L (1999)
6. Install oil seal by using installer J-36830 and grip J-8092. Apply Multipurpose grease NLGI No. 2 or equivalent to the lip portion.
7. Apply Multipurpose grease NLGI No.2 in the hub and bearing.
8. Install hub nut by using wrench J-36827. Turn the place where there is a chamfer in the tapped hole to the outer side, and attach the nut.
PRELOAD ADJUSTMENT
1. Tighten the hub nut to 29.4 Nm (21.7 ft. lbs.), then loosen the nut to the full.
2. Tighten the hub nut to the value given below, using a spring scale on the wheel pin.
BEARING PRELOAD
