Rodeo S 2WD L4-2.2L (1999)
8. Remove leading shoe assembly (8) with upper (inner) return spring (9).
NOTE: Do not over stretch the return spring.
9. Remove upper (inner) return spring (9).
10. Remove hold-down spring and cup (3) and hold-down pin (16).
11. Remove Trailing shoe assembly (7) with parking brake lever (16).
12. Remove parking brake cable from parking brake lever (11).
13. Remove retainer (14), wave washer (13), and parking brake lever (11).
INSPECTION
Check the shoe assemblies for wear by removing brake drum.
Replace the shoe assemblies, if lining thickness is less than 1.0 mm (0.039 inch).
The shoe assemblies have a wear indicator that makes a noise when the linings wear to a degree where replacement required.
Minimum limit: 1.0 mm (0.039 inch)
INSTALLATION