Rodeo S 2WD L4-2.2L (1999)
1. Clean surface of camshaft bracket and HLA.
2. Apply engine oil to journal surface of camshaft bracket and HLA.
3. Install camshaft to cylinder head.
4. Install camshaft bracket according to numerical as shown in the illustration.
The bracket number is:
-
Exhaust: 1 to 5 from front
-
Intake: 6 to 10 from front.
Camshaft oil seal installation area on the cylinder head of No. 1, No. 6 and camshaft bracket rear side plug portion must be applied HN1023 or
equivalent as in the illustration.
5. Tighten camshaft bracket bolts to the specified torque by sequence in the illustration.
Torque: 8 Nm (5.9 ft. lbs.)
NOTE: Camshaft bearing brackets can be identified by number 1 through 10.