Rodeo S 2WD L4-2.2L (1999)
7. Loose fixing bolt of timing belt rear cover, then remove the camshaft angle sensor.
8. Remove ten cylinder head cover fixing bolts and remove the cylinder head cover.
INSTALLATION
1. Install the camshaft angle sensor and tighten timing rear cover bolt.
Torque: 8 Nm (5.9 ft. lbs.)
2. Install the cylinder head cover and tighten bolts to the specified torque.
Torque: 8 Nm (5.9 ft. lbs.)
3. Install the timing belt front cover then tighten fixing bolts to the specified torque.
Torque: 6 Nm (4.4 ft. lbs.)
4. Install the crankshaft pulley, tighten fixing bolts to the specified torque.
Torque: 20 Nm (14 ft. lbs.)
