Rodeo S 2WD L4-2.2L (1999)
-
Lift to remove the upper case.
9. Remove evaporator core.
10. Remove expansion valve.
-
Tear off the insulator carefully.
-
Remove the sensor fixing clip.
-
Use a back-up wrench when disconnecting all refrigerant pipes.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. The sensor is installed on the core with the clip.
2. The sensor must not interfere with the evaporator core.
3. When installing the new evaporator core, install the thermo sensor (2) to the evaporator core (1) specified position with the clip in the illustration.
