Rodeo S 2WD L4-2.2L (1999)
Canister Purge Solenoid: Service and Repair
EVAP Canister Purge Solenoid
REMOVAL
1. Disconnect the negative battery cable.
2. Disconnect electrical connector from EVAP purge solenoid located just front of the ignition coil.
3. Disconnect the vacuum hoses from the solenoid.
4. Remove the ignition coil. Refer to Ignition Coil Removal Procedure.
5. Remove the three bolts holding the ignition coil bracket.
6. Remove the ignition coil bracket with the purge solenoid still attached to it.
7. Insert small screw driver into the catch from the bottom hole to release the catch.
8. Slide EVAP purge solenoid out form the ignition bracket.
INSTALLATION
1. Insert EVAP purge solenoid valve onto the ignition coil bracket.
2. Install the ignition coil bracket to back of intake manifold.
3. Install the ignition coil. Refer to Ignition Coil Installation Procedure.