Rodeo S 2WD L4-2.2L (1999)
Throttle Body Unit: Service and Repair
Throttle Body Unit
NOTE: Do not use solvent of any type when you clean the gasket surfaces on the intake manifold and the throttle body assembly The gasket surface and
the throttle body assembly may be damaged as results.
1. If the throttle body gasket needs to be released, remove any gasket material that may be stuck to the mating surfaces of the manifold.
2. Do not leave any scratches in the aluminum casting.
REMOVAL
1. Disconnect the negative battery cable.
2. Drain the cooling system. Refer to Cooling System.
3. Remove the air intake duct. Refer to Air Intake Duct Removal Procedure.
4. Remove the accelerator cable from throttle. Refer to Accelerator Cable Assembly Removal Procedure.
5. Disconnect the electrical connectors from the throttle position sensor and the idle air control valve solenoid.
6. Disconnect all vacuum hoses below air horn.