Rodeo S 2WD L4-2.2L (1999)
7. Disconnect coolant lines.
8. Remove the mounting bolts retaining the throttle body the intake manifold.
9. Lift up the throttle body from the intake manifolds.
10. Remove the gaskets from the intake manifolds.
11. Remove the IAC. Refer to Idle Air Control Valve Solenoid Removal Procedure.
12. Remove TPS. Refer to Throttle Position Sensor Removal Procedure.
INSTALLATION
1. Install IAC valve onto the throttle body. Refer to Idle Air Control Valve Solenoid Installation Procedure.
2. Install TPS onto the throttle body if necessary. Refer to TPS Installation Procedure.
3. Place the gasket then the throttle body on the manifold.
4. Install four mounting bolt. Tighten the throttle body mounting bolt to 13.5 Nm (10 lb ft).
5. Connect coolant line and secure them with clamps.
6. Connect all vacuum hoses and secure them with clamps if necessary
