Rodeo S 2WD L4-2.2L (1999)
SRS Coil Assembly: Service and Repair
NOTE: In The event deployment has occurred, inspect coil assembly wire for any signs of scorching, melting or any other damage due to excessive
heat. If the coil has been damaged, replace it.
Removal
1. Disable the SRS.
2. Remove the air bag assembly (6) from steering wheel (7) by removing two bolts (8). Lift air bag assembly out of steering wheel.
3. Disconnect the 2-pin yellow connector (2) and remove air bag assembly.
4. Disconnect horn lead connector (1).
5. Remove the steering wheel attachment nut (5).
6. Move the tires to the straight ahead position before removing the steering wheel and remove wheel with J-29752.
7. Apply a setting mark (4) across the steering wheel and shaft so pants can be reassembled in their original position.
8. Feed wiring though the wheel and remove wheel.
9. Remove the steering lower cover.
10. Remove the driver knee bolster assembly.
11. Remove the steering column cover (3).
12. Disconnect the wiring harness connectors (10) located at the base of steering column.
CAUTION: Never apply force to the steering wheel in the direction of the shaft by using a hammer or other impact tools in an attempt to remove
the steering wheel. The steering shaft is designed as an energy absorbing unit.
13. Remove the combination switch assembly with SRS coil (9).
NOTE: SRS coil is a part of combination switch assembly, which cannot be replaced separately. Therefore, be sure not to remove The SRS coil
from the combination switch assembly
Installation
1. Install the combination switch assembly with SRS coil (9).
2. Connect the wiring harness connectors (10) located at the base of steering column.
3. Turn the SRS coil clockwise to full, return about 3 turns and align the neutral mark.
NOTE: Whenever installing the new combination switch with SRS coil, be sure to tear off the lock pin for aligning the neutral position before it is
installed to the base of steering column.
CAUTION: When turning the SRS coil clockwise to full, stop turning if resistance is felt. Forced further turning may damage the cable in the
