Rodeo S 2WD L4-2.2L (1999)
REASSEMBLY
1. Install oil seal to front housing. Be sure to discard used oil seal, and always use new parts for installation.
CAUTION: When installing the oil seal, be careful not to damage the oil seal contacting surface of the housing.
2. Install shaft assembly.
3. Install retaining ring.
4. Install the vanes to rater with curved face in contact with the inner wall calf exam
5. Install rotor and vanes to cam.
6. Install pin to cam.
7. Install two new O-rings to front housing. Be sure to discard used O-ring.
8. Install side plate.
CAUTION: When installing side plate, be careful not to damage its inner surface. Damaged side plate may cause poor pump performance, pump
seizure or oil leakage.